top of page
Riteway Brake Dies
The Pinnacle of Precision Tooling
Box Forming Dies
30 Degree - 60 Degree Layout for deeper box
Note!
Heights on Punches #131 & #131-1 to be + .125 - .000 unless otherwise specified.
In forming a box, where four sides are bent up, the punch must be high enough so that when making the last two bends, the preformed sides do not strike the ram.
The special gooseneck punches shown above may be used to form boxes and channels with long return legs. Die No. 130A can be fastened directly to press bed.
bottom of page